Tgc Bc901h Manual Jun 2026
Runs silently at a ultra-low speed to prevent stagnant air and humidity buildup, even when the bathroom is not in use. 3. Remote Control and Programming Guide
If your specific heater model supports a preheat loop, this button activates the circulation to ensure hot water is ready at the tap. High Temperature Indicator: Lights up when the water temperature is set to 50°C or higher as a safety warning for scalding. www.towngasappliance.com Operation Guide
Are you the proud owner of a TGC BC901H device? Congratulations on taking the first step towards unlocking its full potential! This article aims to provide you with a thorough understanding of your device's capabilities and operations, courtesy of the TGC BC901H manual. tgc bc901h manual
Press the arrows to your desired heat. For safety, if the temperature is set above 50°C, the display may flash. Use Water:
| Problem | Possible Cause | Recommended Action | | :--- | :--- | :--- | | No hot water when tap is opened. | Power supply to the heater or remote is off. Gas supply is off. Minimum water flow not achieved. | Ensure the appliance has power. Check that the gas meter valve is open. Ensure water pressure is sufficient. | | Water temperature is unstable. | Water pressure is fluctuating. Remote control priority is being changed by another user. | Check that no other tap is being used. If another remote is active, wait until it releases priority, or request priority on your remote. | | Green indicator light on remote is off. | The water heater is not in standby mode due to a power or system issue. | Check the main power supply to the water heater. | | Remote control buttons are unresponsive. | The remote does not have priority control. A system error has occurred. | Press a button like the temperature adjuster to request priority. If it still doesn't work, try turning the appliance off and then on again. | Runs silently at a ultra-low speed to prevent
For safety, if the heater is in "standby" (unused) for more than 10 minutes, temperatures previously set above 50°C will automatically reset to 48°C for the next user. Technical Support
TGC BC-90-1H (often referenced as BC901H) is a wired remote control used for TGC (Towngas) High Temperature Indicator: Lights up when the water
Instead of generic “don’t touch moving parts,” they warn:
However, some users mention:
The system automatically adjusts the flame to maintain a constant temperature even if the water flow rate changes. 4. Troubleshooting & Error Codes
Use the "Up" and "Down" arrows to set the water temperature. The standard range is typically 35°C to 60°C Preheat Button (Optional):