Disco 240 Dmx - Controller Manual
: Use the Blackout button to instantly set all DMX output to zero without stopping your sequence. Troubleshooting Tip
Because there are only 8 physical faders but 16 channels per fixture, this button toggles the faders between Channels 1–8 (Page A) and Channels 9–16 (Page B).
| Fader | Channel | Typical Function | |-------|---------|------------------| | 1 | 1 | Pan | | 2 | 2 | Pan Fine | | 3 | 3 | Tilt | | 4 | 4 | Tilt Fine | | 5 | 5 | Speed (Pan/Tilt) | | 6 | 6 | Dimmer | | 7 | 7 | Shutter/Strobe | | 8 | 8 | Color Wheel | | 9 | 9 | Gobo Wheel | | 10 | 10 | Gobo Rotation | | 11 | 11 | Prism | | 12 | 12 | Focus | | 13 | 13 | Zoom | | 14 | 14 | Frost/Effect | | 15 | 15 | Program Speed | | 16 | 16 | Reset/Control | disco 240 dmx controller manual
These buttons store and trigger your programmed sequences (chases), which are strings of multiple scenes played back-to-back.
The controller utilizes an internal microphone or audio line input to trigger chase steps to the beat of the music bass line. : Use the Blackout button to instantly set
: If a light does not respond or acts erratically, ensure the DMX address matches the profile selected on the controller.
Adjust the faders (channels 1-20) and joystick to create the desired look. Press the MIDI/Rec button. Select a Bank (01-30) using the Bank Up/Down buttons. Press a Scene button (1-8) to store the scene. Creating a Chase Enter Program mode. The controller utilizes an internal microphone or audio
Located on the left side, these buttons select which lighting fixtures you are currently controlling. Each button assigns a block of 20 DMX channels to that specific fixture.
Press the MIDI/Rec (or Program/Save ) button, then immediately tap the Scene button (1–8) where you want to store the look. All LEDs on the board will flash, confirming the scene is saved.
