Crawford Cdm9 950 - Installation Manual Top

The electronic unit containing the "C-card" that controls all functions, limits, and safety features.

Route the pre-terminated system cable from the motor unit into the control panel enclosure.

Press the ; the door will move slowly to the floor and then cycle to the fully open position to learn its limits. ⚡ Technical Specifications Supply Voltage: 230V AC, single phase, 50/60Hz. Capacity: CDM9: Standard door weights up to 400 kg. crawford cdm9 950 installation manual top

Fit the initial stop ring onto the hexagonal shaft pivot and position it next to the bearing console.

Crawford CDM9 950 is a heavy-duty industrial door operator system manufactured by ASSA ABLOY Entrance Systems The electronic unit containing the "C-card" that controls

Install the drive chain, ensuring tension is tight but not binding. 2. Manual Disconnect Setup

Check incoming voltage on all phases; ensure the manual chain hoist is completely disengaged. Mechanical binding or force limit profile is too sensitive. ⚡ Technical Specifications Supply Voltage: 230V AC, single

Align the keyway inside the hollow shaft of the CDM9 950 operator with the shaft key. Step 2: Mounting the Operator

: Supports doors up to 400 kg (Standard) or 800 kg (HD version). Power : 230V AC, single-phase, 50/60 Hz, 2A.

Installing the "crawford cdm9 950" is a task that requires a professional approach. By following the guidelines detailed in this article and the official manual, you ensure the system's longevity and the safety of all personnel. Always prioritize correct electrical connections, thorough safety device testing, and proper programming. The Crawford CDM9 with ECS 950 is a powerful system that, when installed correctly, will provide years of trouble-free, high-cycle operation in any demanding industrial environment.